Online Store

Now available online store!

1913 Picatinny spec rail

Carry Beveled and Smoothed for a superior snag-free fit and finish

Low profile design for minimum interference

Works with all surefire, insight technology, and other light and aiming devices that use the 1913 spec

Fits most tactical nylon holsters and all holsters designed for use with light rails

Solid mounting with three heat-treated cap screws - included

Stamped NOVAK'S

Weighs 1.3oz (Carbon & Stainless Steel) .5oz (Aluminum)

Installation instructions or Novak installation available for additional fee ($75.00).

NOW AVAILABLE

STAINLESS STEEL, ALUMINUM, & CARBON STEEL

Price : $59.95

$8.00 for shipping

Click pictures for enlarge.

Contact Us

Order or Questions

304-485-9295

M-F 8am-5pm EST

Please call us for more options.

or

Email to Novak's

GENUINE NOVAK SIGHTS

Find sight you need!

Return Policy

INSTRUCTIONS

FOR NOVAK TACTICAL LIGHT RAIL

TOOL Requirements

• Mill or drill press

• #29 drill bit

• #8-32 tap
• Small half-round file
• 5/64th Allen wrench
• Starter drill bit (#2)

1. Clear and disassemble entire gun.
2. Set frame in vise and level the dust cover.
3. Place rail on dust cover and center. It up with the trigger guard. *IMPORTANT* Before marking holes, check it insure rail is aligned the trigger guard and the rail is not canted side to side. Some dust covers are not perfectly round, so visually verify that the rail is level side to side.
4. Mark holes on to dust cover.
5. Spot holes with #2 starter bit.
6. Remove starter bit and then drill holes with #29 drill bit. Repeat process for remaining holes.
7. Tap holes with #8-32 tap.
8. Install rail and all screws. Check fit and alignment, then tighten screws. *will have very small amount of play when screws are loose or just snug.
9. With screw tight, trim screw excess so they are flush with the inside of the dust cover. *REMEMBER* which screw came from which hole after trimming screws, they are fit to each individual hole.
10. Remove screws apply loctite and retighten.

*Please DO NOT attempt to install this with a hand drill*